Specifications glossary
Technical terms that you need to know
By Editorial Team, Kryzen Biotech
- 31OD (outer diameter)
- The width of a pipe measured across its outside. A "48 mm OD" pipe is 48 mm across from outer edge to outer edge. Clamps and fittings are sized to the OD.
- 32Pre-galvanised
- Steel strip that is galvanised first and then rolled and welded into pipe. The coating is thinner than hot-dip and the weld seam is re-coated after welding. It is smooth, light and cost-effective for most polyhouse members.
- 33Roll-up curtain
- Side film that can be rolled up with a gear unit to let air in, and rolled down to close the polyhouse on cold, rainy or windy days.
- 34Shade percentage
- How much sunlight a shade net blocks. A 50% shade net cuts sunlight by half; a 95% reflective aluminium net blocks almost all direct sun and sends heat back out.
- 35Span
- The width of one arch of the polyhouse, from gutter to gutter. Our polyhouses are built in 8 m spans, so a 24 m wide polyhouse has three spans.
- 36Thermic (IR) film
- Film with an additive that holds back long-wave heat radiation at night, so the polyhouse stays a few degrees warmer after sunset.
- 37UV stabilised
- Additives that slow down the breakdown of plastic in sunlight. Without them, film and nets turn brittle within months; with them they last years.
- 38Virgin HDPE
- HDPE made from new raw material, not recycled plastic. It is stronger, more uniform and lasts longer outdoors.
- 39Wall thickness
- The thickness of the steel that forms the pipe wall, in millimetres. In a size such as 76 × 2.0 × 6500, the 2.0 is the wall thickness. A thicker wall makes a stronger, heavier pipe.
- 40Zig-zag spring(Wiggle wire)
- A wavy spring-steel wire that presses the film or net into the aluminium profile channel and locks it in place. It holds the covering tight without punching holes in it and can be removed to replace the film.
Page 4 of 5 · 42 terms
See these specifications on every product
Browse products →