How it worksBuy individual items

Fan & Pad Polyhouse guide

What is a fan and pad polyhouse?

By Editorial Team, Kryzen Biotech · Updated 12 November 2026

A fan and pad polyhouse is a closed greenhouse cooled by evaporation. Exhaust fans on one end wall pull outside air through wet cellulose pads on the opposite wall. As the water evaporates, the air cools and sweeps across the crop. It is also called a climate-controlled polyhouse.

How a fan and pad polyhouse works: air pulled through wet cellulose pads by exhaust fans
Fans pull outside air through the wet pads; the air cools as it crosses the crop.

How the cooling works

  • Cooling pads

    Cellulose honeycomb pads cover one end wall, with water running over them.

  • Exhaust fans

    Heavy-duty fans with shutters on the opposite wall keep air moving all the time.

  • Pad water system

    A pump, tank and filter keep the pads evenly wet and reuse the run-off.

  • Controls

    A panel switches fans, pump and foggers to hold your set temperature and humidity.

  • Shade or aluminet

    Cuts sun load so the cooling has less heat to remove.

Works best in dry heat

Evaporation cools more when the air is dry. In very humid weather the pads cool less, so check your local climate before choosing fan and pad; our town pages show how far pads can bring the hottest month down.

Typical specification

PartWhat to expect
StructureMulti-span, gutter-connected GI, 2 mm wall, 375–400 GSM
Film200 micron, 5-layer, UV-stabilised
Pads and fansSized to house length, volume and climate
Openings40-mesh UV insect net; air enters only through the pads
Power3-phase supply and backup generator

Material you will order

See all products

Terms used on this page

Fan and pad polyhouse
A closed polyhouse cooled by exhaust fans and wet cellulose pads. It works best in hot, dry weather, where evaporation can bring the inside several degrees below the outside.
Cellulose cooling pad
A block of corrugated paper sheets used in fan and pad polyhouses. Water runs down the pad and air pulled through it is cooled as the water evaporates. 150 mm thick pads are common.
Exhaust fan
A large fan in the wall opposite the cooling pads. It pulls hot air out, which draws cooler air in through the wet pads.

Get fan & pad material from India's biggest CEA manufacturing company

Choose your size and see every item, quantity and weekly rate before you pay.

Build your kit →

FAQs

How much cooler is a fan and pad polyhouse?

In dry heat, several degrees below outside; in humid weather much less. Your town page shows an estimate for the hottest month.

Does it need special film?

No, the same 200 micron, 5-layer UV film as an NVPH; the house is simply closed, without roof vents.

Keep reading

Sources

  1. Kryzen: Fan & Pad Polyhouse
  2. Mission for Integrated Development of Horticulture (MIDH)
  3. National Horticulture Board (NHB)
Build your kit