இது எப்படி வேலை செய்கிறதுதனிப் பொருட்கள் வாங்க

Why Red Cabbage Heads Split Under Protection

Polyhouse Constructions Agronomy Desk · 12 நவ., 2026

Red cabbage head splitting in a polyhouse is usually a water-and-timing problem, not a disease. A head that is already firm cannot expand easily. If the plant suddenly takes up a lot of water and nutrients after a dry spell, inner leaves expand faster than the outer wrapper leaves and the head cracks open.

Start by checking irrigation uniformity, soil moisture in every bed, harvest maturity, and any recent heavy fertigation or temperature change. Split heads will not heal. Harvest usable ones quickly, then correct the cause for the remaining crop.

What a split head tells you

A red cabbage head has tightly packed leaves under pressure. The outer leaves act as a cover, while younger inner leaves keep growing. When growth is slow and steady, the cover stretches gradually. When growth suddenly accelerates, it tears, often from the top or side.

This is why splitting commonly appears in patches rather than across the whole polyhouse. One lateral line may be partially blocked. A low spot in a bed may stay wetter. Plants beside a side curtain may face more heat and water loss. Or a block may simply have reached market maturity before the rest.

Do not confuse head splitting with soft rot or insect damage:

Symptom

More likely cause

What to check first

Clean, fresh crack in an otherwise firm head

Sudden water uptake and rapid growth

Irrigation gap followed by a heavy watering; recent rain entry

Cracks mainly in the largest, oldest heads

Delayed harvest

Firmness and market size across the block

Soft, wet tissue with foul smell around the split

Secondary bacterial or fungal rot

Remove affected heads; improve sanitation and leaf dryness

Many small damaged areas plus frass or chewing

Caterpillars or other pests

Inspect wrapper leaves and inside the crack

Splits concentrated at hot edges or near vents

Uneven microclimate and water stress

Temperature, side-curtain operation and emitter output

A split is an entry point for rot organisms. Separate cracked heads during harvest. If the exposed tissue is clean and sound, it may still sell in a local market quickly, depending on buyer standards. Do not pack heads with wet, decaying or foul-smelling tissue.

The three main triggers: uneven water, late harvest and growth flushes

1. Dry root zone followed by heavy irrigation

This is the most common pattern. The crop is allowed to become visibly stressed, or the bed dries below the active root zone. Then the operator runs drip for a long duration to compensate. Water uptake rises sharply, and mature heads crack.

The same thing can happen after:

  • A pump or filter problem causes one or two missed irrigations.
  • Drippers clog in part of the bed and are later cleaned.
  • Irrigation duration is increased sharply during a hot spell.
  • Water is applied at an irregular interval because of labour or power cuts.
  • Rainwater enters through open sides, roof leaks or poor drainage around the structure.

Cabbage needs moisture to be consistent, especially as the head firms. The target is not permanently wet soil. It is a moist, aerated root zone without severe wet-dry swings.

2. Harvesting after the head is already ready

Red cabbage heads do not improve indefinitely after reaching firm market maturity. Holding them too long while waiting for a higher rate, a truck, or uniform maturity increases splitting risk. Mature heads are less able to accommodate renewed vegetative growth.

Check firmness by pressing the head gently with the palm. A ready head feels solid and dense, not loose and springy. Compare it with the expected size and maturity description of your particular hybrid. Head size, colour and crop duration differ by variety, planting date, altitude and temperature.

Harvest should be planned block by block, not only on one fixed date after transplanting. In a crop with uneven growth, pick the ready heads first and return for smaller plants later.

3. A late sudden growth flush

A flush may follow a large irrigation, a strong fertigation correction, cloudy cool weather after heat, or all three together. Late heavy nitrogen application can encourage soft new leaf growth when the head should be finishing. Excessive irrigation along with high nutrient concentration makes the risk greater.

Do not try to correct small heads by giving a large, one-time fertiliser dose near harvest. Find the reason for slow growth first: poor stand, spacing, root restriction, uneven moisture, high temperature or nutrient imbalance.

Inspect the crop before changing the schedule

Do a short field audit in the morning. This prevents changing the entire irrigation programme based on one symptom.

  1. Map split heads. Mark each affected bed and note whether splits occur near the inlet, end of lateral, sidewall, door or low spot.
  2. Check head stage. Classify plants as loose, filling, firm-ready and overmature. Harvest-ready heads need priority, not extra feeding.
  3. Dig small inspection holes. Check moisture at roughly 10–15 cm and 20–25 cm depth near representative plants. Look for dry zones, standing water and compact layers.
  4. Measure emitter discharge. Collect output from emitters at the beginning, middle and end of several laterals for the same time. Replace clogged or damaged emitters and clean filters as per the system design.
  5. Review the last seven days. Record irrigation duration, fertigation events, power interruptions, cloudy days, heat and any rain entry.
  6. Check drainage. Water should not pond near beds, corners or outside the sidewall where it can seep back into the root zone.
  7. Look for rot and pests. Remove badly split or decayed heads from the house. Inspect healthy heads separately rather than assuming every crack is physiological.

Keep this log for each planting block. It is more useful than relying on a fixed irrigation duration across changing weather.

Build an irrigation routine that avoids moisture swings

Drip irrigation should match crop stage, soil type, weather and plant load. There is no single correct number of minutes or litres for every Indian polyhouse. Sandy beds need smaller, more frequent applications than heavier loam beds. A cool cloudy day needs less water than a dry, warm afternoon.

The key rule near head maturity is: adjust in small steps, not large corrections.

Situation

Risk to red cabbage heads

Better response

Bed is dry and plants show mild stress

A long recovery irrigation can trigger splitting

Restore moisture in controlled, smaller applications; then return to a regular schedule

Hot, bright spell

Faster transpiration and uneven edge-bed drying

Check soil moisture more often; make gradual schedule changes

Cloudy or cool days

Lower water use and overly wet beds

Reduce irrigation carefully; do not keep the old hot-weather duration

Rain blows into open sides

Sudden excess water, especially on edge beds

Close curtains in time, maintain outside drains and inspect affected beds

Fertigation correction late in the crop

Soft, sudden growth

Use a balanced programme based on water and soil or media test results; avoid one heavy catch-up feed

Practical moisture checks

Use more than one method. Feel-and-look checks are useful but should be confirmed with simple tools where possible.

  • Take soil from the active root zone. It should form a weak ball when squeezed in many soils, but should not smear, shine with water or crumble into dust.
  • Install tensiometers or suitable soil-moisture sensors in representative beds if the crop area justifies it. Place them at active root depth, not only at the surface.
  • Check both the inlet and far end of a drip line. Uniform pressure at the pump does not always mean uniform delivery in the bed.
  • Review irrigation after every major weather shift. Do not wait until plants wilt.

Good bed preparation also matters. Raised beds, workable soil structure and clear drainage channels help prevent the cycle of waterlogging followed by drying. Before the next crop, review plant spacing too. Overcrowded plants compete for water and create uneven head development. Use the crop plan alongside this guide to red cabbage spacing for polyhouse head formation.

Manage heat and humidity without creating another stress event

Red cabbage is a cool-season crop. Under protection, excessive daytime heat speeds water loss, weakens head quality and can make irrigation management difficult. A naturally ventilated polyhouse must release heat effectively, particularly in warm afternoons and during unseasonal heat.

Open and close side curtains based on crop conditions and weather, not solely on the clock. Avoid keeping the house shut until plants heat up sharply and then opening it fully all at once. Sudden climate changes add stress, especially around head filling.

At the same time, avoid persistently wet leaves and stagnant humid air. Moist split tissue is highly prone to decay. Maintain drainage, remove damaged heads promptly, and allow enough ventilation when outside conditions permit.

Shade may reduce heat load in some locations and seasons, but it should not be used blindly. Too much shade reduces photosynthesis and may delay maturity. Choose cover and ventilation planning based on local summer temperatures, light levels and crop season. If you are deciding between structures for a future crop, compare NVPH and fan-and-pad systems before investing.

Fertigation and crop handling near maturity

As heads become firm, the aim shifts from pushing leaf growth to keeping plants steady and marketable. Continue providing balanced nutrition according to soil test, irrigation-water quality, crop stage and guidance from a qualified agronomist. Do not stop all nutrition without a reason, but do not apply a heavy late correction either.

Watch for these management errors:

  • Applying a large nitrogen-rich fertigation dose after plants look pale, without diagnosing the cause.
  • Combining a long irrigation with concentrated fertiliser after several dry days.
  • Treating all beds alike when one section has weaker plants or poorer water distribution.
  • Using a last-minute flush irrigation before harvest because the head looks small.
  • Leaving mature heads in the field after the planned harvest window.

If disease symptoms are present, identify the problem correctly. Physiological splits need irrigation and harvest correction, whereas rot requires sanitation and crop-health management. For any crop-protection product, follow the approved label, pre-harvest interval and advice from your KVK or agronomist. Do not spray a product simply because heads have cracked.

Harvest management is your final protection

Begin frequent maturity checks before the expected harvest period for your hybrid. During the main harvest window, inspect the crop every day or every second day, depending on temperature and market access. A few days can matter once heads are fully firm.

Harvest in the cooler part of the day where practical. Cut heads with enough wrapper leaves to protect them in handling, but remove badly damaged, decaying or soil-contaminated outer leaves. Keep harvested heads shaded and move them promptly for grading and dispatch.

Use a simple decision rule:

  • Firm, uncracked, market-size head: Harvest and grade.
  • Firm head with a clean shallow split: Segregate for quick local sale if acceptable to the buyer.
  • Deep split with wet, discoloured or soft tissue: Reject from premium packing; keep it away from sound produce.
  • Loose head still filling: Maintain steady irrigation and reassess separately; do not use extra water as a shortcut.

Staggered transplanting and realistic market planning reduce the temptation to hold a whole crop beyond maturity. If harvest is delayed by a buyer issue, prioritise the oldest and firmest beds first.

Prevent splitting in the next red cabbage crop

The best prevention starts before transplanting. Prepare level, well-drained beds and test the irrigation system before seedlings go in. Confirm that all laterals deliver evenly and that filters, pressure regulation and drainage are working.

For protected cultivation, structure design also influences how easily you can manage edge heat, wind-driven rain and ventilation. Learn the operating basics in what is an NVPH, and review relevant cover, net and fitting options under protected cultivation materials when planning repairs or a new house.

Use this pre-season checklist:

  • Level beds and maintain drainage paths inside and outside the structure.
  • Check water quality, filtration, pressure and emitter uniformity.
  • Plan irrigation by soil type and season, with capacity for smaller frequent adjustments.
  • Select a suitable red cabbage hybrid for your planting season and market.
  • Keep correct spacing and replace weak seedlings early where feasible.
  • Record transplant date, expected maturity range, irrigation changes and first harvest dates.
  • Arrange harvesting and buyers before the crop reaches its main maturity window.

Next steps

For the current crop, harvest all firm heads first, remove decaying split heads, and audit drip output and root-zone moisture bed by bed. Then stabilise irrigation rather than making one large correction.

For the next planting, use your records to improve drainage, irrigation uniformity and harvest scheduling. If you are planning or upgrading a protected structure, you can build a material kit and see this week’s item-wise rates for the required components.

Frequently asked questions

Can split red cabbage heads close or recover?

No. The torn wrapper leaves do not fuse again. Harvest clean, sound split heads quickly if your buyer accepts them, and remove heads showing wet rot or decay.

Does heavy rain cause red cabbage splitting inside a polyhouse?

It can if rain enters through open sides, leaks, or drains toward the beds. Edge rows and low-lying areas are usually affected first, so inspect these sections after rain.

Should I stop irrigation when red cabbage heads become firm?

Do not stop irrigation completely, as that can stress the plants and create another moisture swing later. Reduce and adjust water only according to soil moisture, weather and crop stage, while keeping the root zone even.

Can excess fertiliser split cabbage heads?

A sudden late fertigation application, especially when combined with heavy watering, can cause a rapid growth flush and raise splitting risk. Base corrections on a soil, water or crop assessment rather than applying a catch-up dose.

Which red cabbage heads should be harvested first to prevent splitting?

Pick the oldest heads that feel firm, dense and meet the buyer’s size requirement. Do not wait for smaller heads in the same bed to catch up if the larger ones are already mature.

உங்கள் கிட்டை உருவாக்குங்கள்