Tomato Polyhouse Fertigation Schedule for Indian Crops

Polyhouse Constructions Agronomy Desk · ನವೆಂ 13, 2026

Tomato fertigation in a polyhouse works best when it follows the crop, not a fixed calendar. Give small, frequent irrigations; keep nitrogen balanced in early growth; increase potassium as flowering and fruit load rise; and maintain calcium throughout the crop.

For most soil-bed indeterminate tomatoes, begin with a mild feed after transplant establishment, use a balanced N:K programme during vegetative growth, and shift gradually towards higher potassium from flowering until final picking. Adjust every week using irrigation-water EC, soil or root-zone EC, plant vigour, fruit load and the season.

Set the baseline before the first fertigation

Do not copy another farm's fertiliser quantity without checking your soil and water. A crop on light red soil in Maharashtra, black cotton soil in Karnataka, or sandy soil in Rajasthan will not behave the same way. The same is true for borewell water with high bicarbonates or salts.

Before transplanting, arrange these tests:

  • Soil test: Check pH, EC, organic carbon, available phosphorus and potassium, calcium, magnesium and micronutrients. Also check nematode risk where tomatoes have been grown repeatedly.
  • Irrigation-water test: Test EC, pH, bicarbonates, sodium, chloride, calcium, magnesium and iron. Borewell-water quality can change between summer and monsoon.
  • Drip-system check: Measure the discharge of a few drippers at the head, middle and tail ends of each lateral. Flush lines before planting.
  • Fertigation equipment check: Ensure filters, venturi or dosing pump, stock tanks and non-return valves are working. A poorly filtered system causes uneven nutrition even when the fertiliser recipe is correct.

For a new soil-bed crop, incorporate well-decomposed organic matter and the required basal amendments only as guided by the soil test. Do not try to supply the whole season's nutrient need as a basal dose. Tomato needs change sharply once fruiting starts, so most soluble nutrition should come through the drip.

A healthy transplant is the starting point for a uniform programme. Use this tomato polyhouse transplanting checklist before you begin irrigation and fertigation.

Tomato fertigation targets by crop stage

The table below is a practical framework for indeterminate table tomato or cherry tomato grown in polyhouse soil beds. Days after transplanting (DAT) are approximate. A fast summer crop may reach flowering earlier, while a cool-season crop may take longer.

The N:K figures show the relative direction of nutrient supply, not a ready-to-mix fertiliser formula. Final quantities must be calculated from your plant population, soil test, water analysis, fertiliser grade and expected yield.

Crop stage

Approx. crop age

Irrigation guide per plant per day*

Fertigation focus

Working root-zone target

Establishment

0–14 DAT

0.3–0.8 L

Mild, balanced feed; support root establishment; avoid excess salts

pH about 5.5–6.5; low EC, often 1.2–1.8 mS/cm

Vegetative growth

15–30 DAT

0.7–1.8 L

Build a sturdy canopy, but avoid soft overgrown plants; N:K near 1:1 to 1:1.2

Often 1.5–2.2 mS/cm

First flowering and fruit set

31–50 DAT

1.5–3.0 L

Steady calcium, boron and balanced nutrition; gradually raise K; N:K about 1:1.3–1:1.5

Often 1.8–2.5 mS/cm

Fruit enlargement

51–85 DAT

2.5–4.5 L

Potassium becomes more important; maintain calcium and magnesium; N:K about 1:1.5–1:2

Often 2.0–3.0 mS/cm

Regular picking

86 DAT onward

3.0–5.5 L or more in hot weather

Replace nutrients removed by harvest; keep K high without starving N or Ca; N:K about 1:1.8–1:2.5

Often 2.2–3.2 mS/cm

*These are broad starting ranges for well-rooted soil-bed plants under drip. Water need varies greatly with bed soil, mulch, plant spacing, crop age, solar radiation, ventilation, temperature and drainage. In peak May heat, mature plants may need more water; during cloudy monsoon days, they may need much less.

0–14 DAT: establishment

For the first few days, irrigate enough to wet the root zone around each plug without keeping the full bed saturated. Too much water at this stage reduces root oxygen and delays establishment.

Start fertigation only after seedlings have recovered from transplant shock and started new root growth. Use a low-strength, balanced nutrient solution. Phosphorus is important in this period, but do not keep high phosphorus running for the entire crop. Maintain a modest supply of nitrogen, potassium, calcium, magnesium and micronutrients.

15–30 DAT: build the plant, not excessive leaves

As plants are tied and trained, increase water and nutrient supply gradually. Nitrogen supports leaf area and stem growth, but overfeeding nitrogen produces long internodes, dark soft leaves and a humid canopy. Such plants are more prone to poor fruit set and disease pressure.

Keep potassium close to or slightly above nitrogen. This helps build a more balanced, generative plant before the first heavy flowering flush. Begin regular monitoring of new leaves, stem thickness and early flower trusses.

31–50 DAT: flowering and early fruit set

This is the stage where irregular watering causes trouble. Drought followed by heavy irrigation can lead to flower drop, misshapen early fruit and later cracking. Use multiple short pulses rather than one long irrigation, especially on lighter soils.

Increase potassium gradually. Continue calcium in every suitable fertigation cycle because calcium movement depends on steady transpiration and water uptake. Avoid making sudden EC jumps just because flowering starts. A sharp jump can stress roots and reduce fruit set.

51 DAT to final picking: fruit filling and harvest

As fruit load rises, the crop needs more total water and more potassium. Potassium supports fruit sizing, colour and soluble solids, while adequate nitrogen is still needed to maintain productive leaves. Cutting nitrogen too early leads to weak plants, pale foliage and poor continuation of upper trusses.

Calcium and magnesium must remain in balance. Excess potassium can restrict magnesium uptake, while excessive ammonium nitrogen can interfere with calcium uptake. Keep the programme stable and make small weekly changes based on crop response.

For cherry tomato, avoid wide swings in irrigation and EC during ripening. Those swings are a common contributor to cracking. See this guide on preventing fruit cracks in polyhouse cherry tomato for the crop-management side of the issue.

Prepare fertiliser stocks and run each irrigation correctly

A good nutrient plan fails if incompatible fertilisers form deposits in the stock tank or if fertiliser remains in the lateral after irrigation ends.

Keep incompatible materials separate

Use separate stock tanks where required:

  • Tank A: Usually calcium nitrate and compatible iron chelate.
  • Tank B: Usually phosphates, sulphates, potassium fertilisers, magnesium sulphate and most micronutrient mixes.
  • Never mix calcium nitrate directly with sulphates or phosphates in a concentrated stock solution. It can form precipitates and clog filters and drippers.

Choose fully water-soluble fertilisers. Dissolve each material completely in clean water before it enters the stock tank. Use a separate clean stirrer for each tank.

Sequence each irrigation event

  1. Run plain water first to pressurise lines and wet part of the root zone.
  2. Inject the nutrient solution during the middle portion of the irrigation cycle.
  3. Finish with plain water for enough time to clear fertiliser from laterals and drippers.
  4. Record water volume, fertiliser used, injection duration, inlet EC and pH, and any filter cleaning.

A typical summer day may need several short irrigation pulses. In cool, cloudy or rainy weather, reduce both water volume and the number of pulses. Do not keep the same summer schedule during monsoon simply because the crop is at the same DAT.

Match the programme to water quality

Water quality decides how much fertiliser room is available. If source water already has EC of 1.0 mS/cm, a final irrigation EC of 2.5 mS/cm leaves much less space for fertiliser than water with EC of 0.3 mS/cm.

Important water-test readings

Water issue

What it can cause

Practical response

High EC

Salt stress, weak water uptake, smaller fruit

Use lower-strength feeds, provide suitable leaching irrigations where drainage allows, and monitor root-zone EC closely

High bicarbonate and high pH

Rising root-zone pH; reduced iron, zinc and phosphorus availability

Acidify only under agronomist guidance; calculate acid need from water alkalinity, not pH alone

High sodium

Poor soil structure and reduced infiltration over time

Improve drainage, use calcium-based amendment only as advised by soil test, and avoid sodium-containing fertilisers

High chloride

Leaf-edge burn and salinity stress in sensitive crops

Avoid chloride-heavy inputs and manage overall salt load

High iron or suspended particles

Emitter blockage and uneven fertigation

Use suitable filtration and periodic line maintenance

pH alone is not a complete water-quality report. High-bicarbonate water can resist pH correction and keep pushing soil pH upward. Get alkalinity measured rather than relying only on a handheld pH meter.

Where acid injection is needed, it must be handled by trained people using compatible equipment and safety gear. Never guess the dose. Acid choice and quantity depend on bicarbonate level, water volume and existing nutrient supply.

Monitor plants, root zone and drainage every week

Use crop observation together with measurements. A leaf symptom seen today may reflect irrigation or nutrient decisions made one or two weeks earlier.

Check the following each week:

  • New growth: It should be neither very thin and pale nor overly thick and dark green.
  • Flower trusses: Watch for uneven fruit set, poor pollen release or excessive vegetative growth.
  • Fruit quality: Monitor size, firmness, blossom-end rot, shoulder colour and cracking.
  • Root-zone moisture: Dig carefully near a dripper or use moisture sensors. The root zone should be moist, not constantly waterlogged or dry between pulses.
  • EC and pH: Check source water and fertigation solution. In soil beds, use a consistent soil-solution or saturated-paste method so weekly values are comparable.
  • Dripper uniformity: Walk the house regularly. A blocked dripper can create a nutrient-deficient plant beside a healthy one.

For cocopeat or other substrate bags, collect drain water from representative plants. Drain EC that keeps rising above the feed EC indicates salt accumulation. For soil beds, drainage is usually not available to measure, so root-zone sampling and soil-moisture checks become more important.

Do not correct every symptom by adding more fertiliser. Blossom-end rot, for example, is often linked to irregular water movement and poor calcium transport, not simply a shortage of calcium in the tank. Similarly, lower-leaf yellowing may be normal ageing during heavy harvest, or it may signal a genuine nitrogen or magnesium issue. Confirm the cause before changing the recipe.

Common fertigation errors in Indian polyhouses

The most costly errors are usually management errors rather than a lack of expensive fertilisers.

  • Giving one large daily irrigation instead of short pulses suited to weather and soil.
  • Increasing fertiliser concentration when plants wilt in hot afternoons, even though root-zone salinity is already high.
  • Running high nitrogen throughout the season and getting excessive foliage with weak fruiting.
  • Reducing nitrogen too sharply after first harvest, causing the upper crop to lose vigour.
  • Ignoring calcium during fruiting or mixing calcium nitrate with incompatible fertilisers.
  • Using the same recipe despite changes in borewell EC, monsoon cloud cover or fruit load.
  • Not flushing filters and laterals, leading to uneven nutrition across beds.

Training and pruning also influence nutrition demand. A crop carrying too many stems or fruit clusters cannot be corrected by fertigation alone. Follow a planned canopy system such as this cherry tomato pruning and training method.

Next steps

Prepare a one-page fertigation register before planting. Enter your soil test, water analysis, plant population, target harvest period, weekly fertiliser plan, irrigation volumes, EC and crop observations. Review it every seven days and make gradual changes rather than sudden corrections.

If you are planning a naturally ventilated structure for tomato, understand the crop environment first through what an NVPH is. For structure materials and component quantities, you can also build a polyhouse material kit with live weekly rates.

Frequently asked questions

How many times a day should tomato be fertigated in a polyhouse?

During early establishment, one or two short irrigations may be enough depending on soil moisture. In hot weather at fruiting, growers often use several short pulses, but the right number depends on dripper discharge, soil type, sunlight and plant size.

What EC is suitable for tomato fertigation in soil beds?

A working root-zone EC often falls around 1.5–3.0 mS/cm, with lower levels for young plants and higher levels during fruit load. The correct target must account for the EC already present in your irrigation water and soil.

Can calcium nitrate and NPK fertiliser be mixed in one tank?

Calcium nitrate should not be mixed in concentrated stock with fertilisers containing sulphates or phosphates. Keep calcium nitrate in a separate stock tank to prevent precipitates and dripper blockage.

Should potassium be increased during tomato fruiting?

Yes, potassium demand generally rises from flowering through fruit enlargement and regular harvest. Increase it gradually while retaining sufficient nitrogen, calcium, magnesium and micronutrients for continued plant growth.

Why do tomato plants show blossom-end rot even after calcium fertigation?

Blossom-end rot often results from interrupted calcium movement into developing fruit due to irregular irrigation, salinity stress or damaged roots. Check moisture consistency, root-zone EC and ventilation before simply adding more calcium fertiliser.

ನಿಮ್ಮ ಕಿಟ್ ತಯಾರಿಸಿ