આ કેવી રીતે કામ કરે છેઅલગ સામગ્રી ખરીદો

Red Cabbage Spacing in Polyhouse for Uniform Head Formation

Polyhouse Constructions Agronomy Desk · 12 નવે, 2026

Red cabbage spacing in polyhouse should usually be 45 × 45 cm to 50 × 50 cm, measured plant to plant and row to row. Start with 45 × 50 cm when the buyer wants medium, uniform heads; use 50 × 50 cm for large-head varieties, humid weather, or a crop expected to grow very vigorous.

Avoid treating closer spacing as an automatic route to more saleable yield. It may raise plant count, but crowded plants compete for light and root space. The usual result is smaller heads, a damper crop canopy and less even purple-red colour. This checklist helps you set out beds and match population to your target market.

Use this spacing and population checklist first

Before transplanting, decide the head weight and size your market accepts. Red cabbage is normally sold as a whole head, so uniformity matters as much as total weight harvested.

A useful general target is about 4 to 5 plants per m² of planted bed area. Lower populations suit larger heads; higher populations suit a medium-head programme only when temperature, nutrition and airflow are managed well.

Compare red cabbage spacings before marking beds

The figures below are theoretical populations. Actual counts reduce when bed margins, pathways, drainage channels and non-planted ends are removed. Calculate your planting material requirement from the marked planting positions, then keep a small number of extra hardened seedlings for early gap filling.

Spacing (row × plant)

Plants per m² of planted bed area

Best fit

Main caution

40 × 45 cm

About 5.6

Compact varieties and a medium-head market, only in cool, dry conditions with strong air exchange

Higher canopy humidity and smaller head potential

45 × 45 cm

About 4.9

A common medium-head option in well-managed beds

Can become crowded with vigorous varieties

45 × 50 cm

About 4.4

A practical balance of head size, crop access and population

Maintain an even grid; irregular gaps affect uniformity

50 × 50 cm

4.0

Large-head varieties, humid periods and growers prioritising airflow

Fewer plants per bed, so avoid poor plant establishment

For example, at 45 × 50 cm, divide planted bed area in m² by 0.225 to estimate plant count. A 100 m² planted bed area holds roughly 444 plants. Do not use the outer structure size in this calculation: paths and service space are not growing area.

If you are planning a protected-crop layout for the first time, the basics of a naturally ventilated polyhouse are useful to understand. Red cabbage needs a cool, well-ventilated crop environment, not a sealed, humid canopy.

Match spacing to the head size your market wants

Spacing changes how the crop shares light, water and nutrients. It cannot correct a variety that is unsuitable for the season, but it strongly influences whether otherwise healthy plants make a uniform head.

For medium, compact heads

Use 45 × 45 cm or 45 × 50 cm where buyers want manageable heads and the variety is described as compact. This population can use the bed efficiently. But it works only when plants receive even fertigation, beds drain freely and side ventilation is not restricted.

At this spacing, do not allow early weed growth or missed plants to create an uneven crop. Large gaps allow neighbouring plants to spread, producing oversized heads beside smaller crowded ones.

For larger heads

Use 50 × 50 cm when the variety naturally produces a broad leaf frame or when the target is a larger head. Each plant receives more root zone and light around its outer leaves. This improves the chance of a well-filled head rather than a tight group of undersized plants.

Wider spacing is also the safer choice during periods when daytime heat and night humidity are difficult to manage. It does not remove disease risk, but leaf surfaces dry more readily when plants are not touching early.

Do not select a very close grid just to increase count

At 40 × 45 cm, plant population rises sharply. That can be useful for genuinely compact varieties in a favourable cool period, but inspect the crop closely after canopy closure. If outer leaves overlap heavily, the centre of the bed stays damp longer after irrigation or condensation.

In a crowded crop, the harvest may contain more heads but lower average head weight and more variation. For premium sales, a uniform 4 to 5 plants per m² is often easier to manage than a very dense stand.

Lay out raised beds and transplant to the exact grid

A level, well-drained bed makes spacing meaningful. If bed width forces you to bend rows or plant along the sloping shoulder, actual root space becomes uneven.

Set bed width before selecting row arrangement

Choose a bed width that allows rows to follow a straight grid while leaving access paths for scouting and harvest. On a 1 m usable bed, two rows at 50 cm apart can fit comfortably if the row centres are set in from each edge. On wider beds, use a simple rectangular grid that lets a worker reach the centre without stepping on the bed.

Do not make the outermost row too close to the edge. Edge plants often receive different moisture and temperature conditions, and can become noticeably larger or smaller than centre plants.

A field-ready planting procedure

  1. Prepare moist, loose beds with reliable drainage. Do not transplant into waterlogged soil or media.
  2. Stretch a marked rope, use a planting frame, or mark rows with a measuring tape. A visual estimate causes cumulative errors by the last row.
  3. Mark both row spacing and in-row spacing. For 45 × 50 cm, keep every row 45 cm apart and every plant within the row 50 cm apart.
  4. Transplant hardened seedlings late afternoon or on a relatively cool day. Keep the plug intact and set it at its nursery depth; do not bury the growing point.
  5. Water in immediately and ensure each dripper wets the intended root zone. Confirm that all rows receive comparable flow.
  6. Review the layout after 7 to 10 days. Replace only plants that fail early, using similar-age seedlings. A much younger replacement will not match harvest size.

Healthy, hardened transplants are essential before setting any spacing. Review this vegetable seedling hardening checklist if seedlings have come from a nursery or plug-tray unit.

Protect air movement and uniform purple-red colour

Red cabbage gets its characteristic colour from anthocyanin pigments. Variety, temperature and light exposure all influence the final shade. Spacing cannot create colour by itself, but an open, even canopy prevents some of the conditions that lead to uneven colour and variable maturity.

Cool growing conditions generally support good head development and colour expression. In hot spells, plants may grow unevenly, form looser heads or show less attractive colour, depending on variety. A polyhouse should therefore be ventilated early rather than left closed until plants show heat stress.

Keep these practical points in mind:

  • Open side curtains or vents as conditions warm, while avoiding harsh direct drafts on very young plants.
  • Keep insect net and vents clean. Dust and blocked openings reduce both airflow and useful light.
  • Avoid unnecessary shade during the main vegetative and head-forming period. Excess shade and a crowded canopy reduce light reaching lower leaves.
  • Maintain even soil moisture. Severe dry-wet cycles cause uneven growth and can later increase the risk of head splitting.
  • Keep foliage as dry as practical. Apply irrigation at the root zone and avoid long periods of wet leaves.
  • Scout the centre rows, not only the edges. The densest, most humid zone usually reveals spacing or ventilation problems first.

White diffused covering can help distribute light more evenly across a protected structure, but it does not replace crop-level airflow. Where ventilation is weak or summer conditions are severe, understand the difference between NVPH and fan-and-pad systems before selecting a crop season or planting density.

Adjust spacing with irrigation, nutrition and disease prevention

A wider grid does not mean each plant should receive excessive water or fertiliser. Red cabbage still needs a balanced programme matched to soil test, water quality, growth stage and variety. Excess nitrogen can encourage soft, leafy growth and delay firm heading, particularly when plant population is already high.

Use short, measured irrigation events rather than allowing prolonged saturation. Check moisture at root depth in both centre and edge rows. Uneven wetting creates unequal plant size, even where spacing is exact.

Dense canopies also need more careful disease monitoring. Watch for persistent wet leaves, yellowing lower leaves, spots, wilting plants or a sour smell around poorly drained patches. Remove badly affected plants and crop debris from the protected area as advised by your agronomist. For any plant-protection product, follow the label and guidance from your KVK or crop adviser; do not choose products or doses by guesswork.

Good spacing supports preventive management, but it should sit alongside sanitation, clean water, drainage and pest exclusion. The same canopy principles are discussed in this guide to broccoli transplant spacing under protected cultivation, another cool-season brassica crop.

Correct common spacing mistakes before heads form

Most spacing problems become visible during the vegetative stage. Walk every bed weekly and compare the centre row with the edge rows.

What you see

Likely reason

Practical correction

Centre plants are smaller and leaves overlap early

Population is too high, or variety is more vigorous than expected

Improve ventilation; avoid adding excess nitrogen; use wider spacing in the next planting

Edge plants are much larger than inner plants

Uneven light, root space or irrigation distribution

Check bed-edge drippers, row placement and side-vent effects

Damp lower leaves persist after irrigation

Close canopy, poor drainage or weak air exchange

Correct drainage, irrigate to root need and improve ventilation

Purple colour is uneven across the house

Variation in variety, temperature, light or crop vigour

Check climate differences between bays and maintain an even irrigation/nutrition programme

Heads are too small but plants are healthy

Spacing may be too close, or crop nutrition/water is limiting

Review actual plant count, soil test and fertigation uniformity before next crop

Do not thin established plants late merely to create room. The remaining plants may grow larger, but the crop will be uneven and the removed plants are a direct loss. Use the observation to correct the next planting plan instead.

Next steps

Measure one representative bed, subtract pathways and unplanted margins, then choose 45 × 50 cm as a sensible first red cabbage spacing in polyhouse unless your variety or buyer clearly requires a different size. Mark the complete grid before transplanting, record the plant count, and compare head weight from centre and edge rows at harvest.

If ventilation or covering material needs attention before the cool-season crop, review polyhouse materials and make a layout list first. For a structure-material requirement, you can also build a kit and view this week’s item rates.

Frequently asked questions

What is the best red cabbage spacing in a polyhouse?

For many crops, 45 × 50 cm is a practical starting point. Use 45 × 45 cm for compact medium-head varieties under strong management, and 50 × 50 cm where larger heads or more canopy airflow are required.

How many red cabbage plants fit in 1,000 m²?

At 45 × 50 cm, theoretical population is about 4,444 plants in 1,000 m² of actual planted bed area. The final number will be lower if the 1,000 m² includes pathways, drains, border space or service areas.

Can I plant red cabbage at 40 × 40 cm in a polyhouse?

This is a dense planting of about 6.25 plants per m² and is generally suitable only for compact varieties and a medium or small head target. In humid or warm conditions it can reduce airflow and increase variation in head size.

Does wider spacing make red cabbage heads larger?

Wider spacing gives each plant more light, root area and access to water and nutrients, so it can support larger heads. However, head size also depends on variety, season, temperature, irrigation and crop nutrition.

Why is red cabbage colour uneven under protected cultivation?

Uneven colour can result from variety differences, high temperature, irregular light, uneven irrigation and non-uniform crop vigour. Close spacing can worsen the issue by creating an uneven, shaded canopy, especially in the centre rows.

તમારી કિટ બનાવો