How it worksBuy individual items

CO2 Generator vs Cylinder for Polyhouse Enrichment

Polyhouse Constructions Agronomy Desk · 13 Nov 2026

CO2 enrichment works only when a crop is actively photosynthesising and the polyhouse can remain reasonably closed. In the CO2 generator vs cylinder polyhouse decision, cylinders are usually the better starting point because they supply clean, dry CO2 without adding heat or water vapour. A fuel-fired generator may reduce the cost per kg of CO2 in a large controlled house, but it raises the need for combustion safety, ventilation planning and continuous monitoring.

Do not add CO2 to a naturally ventilated polyhouse while side curtains or roof vents are open. Much of the gas will escape. First assess whether enrichment is worthwhile for your crop and structure, then select the source.

The quick comparison

A compressed CO2 cylinder stores gas produced elsewhere and releases it through a regulator and distribution line. A CO2 generator burns a clean fuel, usually LPG or natural gas, inside the house. Complete combustion produces carbon dioxide, but also water vapour and considerable heat.

Factor

CO2 cylinder

Fuel-fired CO2 generator

CO2 quality at crop

Predictable when cylinder gas and equipment are suitable

Depends on clean fuel, complete combustion and maintenance

Heat added to house

Negligible

Significant; may help in cold weather but harms summer control

Moisture added

None in normal use

Adds water vapour, raising RH and condensation risk

Reliability

Depends on cylinder stock, refill delivery and leak-free fittings

Depends on fuel supply, burner condition, ignition and power/control system

Safety concern

High-pressure storage and asphyxiation from leaks

High pressure/fuel plus fire, combustion and harmful exhaust risks

Best fit

Small to medium sealed zones; trials; precise control

Large, well-managed houses where heating and humidity are controlled

Monitoring need

CO2 level, leak checks and cylinder pressure/weight

CO2, temperature, RH, combustion condition and carbon monoxide alarm

Neither source is a substitute for sound climate management. If crop temperature, light, irrigation, nutrition or humidity are limiting, extra CO2 will not give the expected response.

First decide whether your polyhouse can hold CO2

CO2 is most useful during daylight, often in the morning when natural CO2 inside a closed crop canopy can fall below outdoor levels. But enrichment has poor value when exhaust fans run continuously, pad cooling is active, or vents and curtains are open.

This is why structure type matters:

  • Naturally ventilated polyhouse (NVPH): In most Indian summer conditions, vents and side curtains need to remain open for crop safety. Cylinder enrichment may be used only in short, relatively closed morning or winter periods, if measurements show a benefit. A fuel-fired generator is generally a poor fit.
  • Fan-and-pad polyhouse: It can retain CO2 better during selected cool hours when fans are off or at minimum ventilation. Yet once exhaust fans operate, CO2 is quickly removed. The controller must prioritise crop temperature over CO2 retention.
  • Nethouse: It is too open for practical enrichment. CO2 dissipates rapidly.
  • Partitioned growing zone: A smaller, well-sealed compartment can be more economical to enrich than a whole acre-scale house.

Before spending on equipment, read the related guidance on when CO2 enrichment is worth it in a polyhouse. Also ensure the cooling system is correctly matched: poor fan-pad balance causes heat stress long before CO2 becomes the main issue. See how to calculate exhaust fan size.

Cylinder systems: cleaner control, but plan supply well

A cylinder system normally includes a secured cylinder, suitable regulator, pressure-rated hose or piping, solenoid valve, flow control, distribution tubing and a CO2 controller. The controller opens the solenoid only when the measured level is below the set point and the house is in a suitable operating state.

Where cylinders perform well

Cylinders are practical for a pilot block, nursery compartment or small-to-medium fan-and-pad unit. They are also useful where the crop needs precise, repeatable conditions, such as high-value seedlings, flowers or intensive vegetable production.

Their chief advantage is that no combustion happens in the crop space. They do not add humidity, which matters during cloudy monsoon weather and winter mornings when condensation and leaf wetness can already favour disease. They also do not add unwanted heat when outside temperatures are high.

Use a gas supplier and grade appropriate for horticultural use. Keep cylinders upright, chained to a rigid support, shaded from direct sun and protected from physical impact. Never lay a cylinder loose on the floor or move it by rolling.

Cylinder limitations

The running cost depends on local gas availability, transport, refill terms, leakage and the actual enrichment hours. A low-priced cylinder can become expensive if it leaks at connectors or is released while vents are open. Plan for refills before peak crop demand; an empty cylinder during a critical morning period defeats the purpose.

Cylinder pressure alone is not a reliable indication of remaining liquid CO2 for many cylinder types. Maintain a simple log of cylinder weight, start date, end date, controller hours and crop block. This helps identify leaks and estimate future requirement.

Generator systems: CO2 plus heat and water vapour

A fuel-fired generator produces CO2 at the point of use. This can be attractive where fuel is reliably available and the enriched volume is large. However, the same combustion reaction releases heat and water vapour. These are not minor side effects in an Indian protected-cultivation house.

For example, burning hydrocarbon fuel creates both CO2 and water. The exact amount varies with fuel and generator efficiency, but the extra moisture can push relative humidity upward. In a dense tomato, cucumber, capsicum or flower crop, that can increase condensation on leaves and flowers when air circulation is weak.

Heat can be useful only in the right season

In a cold North Indian winter morning or a high-elevation production area, generator heat may partly support warming. Even then, do not treat a CO2 generator as a properly sized heater. Heat distribution, thermostat control and combustion safety are different requirements.

Across much of India, daytime temperatures rise quickly. The generator’s added heat may trigger exhaust fans sooner. Those fans then remove the CO2 you just generated. This is the central operating conflict: the equipment can create CO2 at the same time that the climate system is expelling it.

Combustion quality is non-negotiable

Incomplete combustion can create carbon monoxide, ethylene and other damaging contaminants. Even low levels of ethylene may distort growth, cause flower or fruit problems, and reduce marketable yield in sensitive crops. Never use an improvised burner, vehicle exhaust, kerosene device, charcoal burner or unverified heating appliance as a CO2 source.

A generator needs correct installation, clean fuel, scheduled servicing, proper air supply and alarms. If flame colour, ignition behaviour, smell, crop symptoms or sensor readings change, stop operation and have a competent technician inspect the unit. Do not try to correct combustion faults by increasing runtime.

Safety requirements for both options

CO2 is colourless and odourless. At high concentrations it can displace oxygen and endanger workers, especially in low points, pits or enclosed service rooms. A crop-safe target level is not a worker-safety system.

Use this checklist before each enrichment season:

  1. Install a calibrated CO2 sensor at crop-canopy height, away from direct injection points, doors, fans and fogger discharge.
  2. Install a separate worker-area safety alarm where people enter, particularly near cylinder banks or a generator.
  3. Interlock injection with ventilation. CO2 should stop when exhaust fans, large vents or emergency ventilation are active.
  4. Fit an emergency stop that workers can reach easily. Train all staff on it.
  5. Keep a written entry rule: ventilate first and do not enter an alarmed or suspected high-CO2 area alone.
  6. For generators, add a carbon monoxide alarm and inspect the burner, fuel line and ignition system as per the manufacturer’s service schedule.
  7. Check all cylinder joints using an approved leak-testing method. Never search for leaks with a flame.
  8. Keep fuel cylinders, CO2 cylinders and electrical controls protected from rain, standing water and farm traffic.

The crop sensor should not be your only sensor. Sensors drift with time and contamination. Follow the manufacturer’s calibration procedure and compare readings with a known reference periodically. Sensor placement and number matter; see where to place temperature and humidity sensors in a polyhouse and how to select a climate controller.

Monitoring and operating strategy

For many vegetable and flower crops, a daytime target moderately above ambient is considered before moving to higher enrichment. Common operating targets are often in the range of 700–1,000 ppm, but the appropriate level depends on crop, light, temperature, ventilation rate and economics. Do not assume that a higher target always pays.

Run enrichment only when all these conditions are broadly met:

  • The crop has enough daylight for active photosynthesis.
  • Temperature is within the crop’s productive range.
  • Fans and vents are closed or at very low minimum ventilation.
  • Crop water status and nutrition are adequate.
  • The measured CO2 level is below the controller set point.

Start with a conservative set point and short morning operating window. Compare crop performance, gas use and climate records over several weeks against an untreated comparable block where possible. Use the results, not assumptions, to decide whether to expand.

For generator users, the controller should also stop the unit at high temperature, high RH, ventilation demand, carbon monoxide alarm and flame-failure condition. For cylinder users, it should close the solenoid on power failure where the valve design permits, preventing uncontrolled discharge.

Choosing by farm situation

Choose a cylinder system if you are starting enrichment, operating a small enclosed zone, growing in warm or humid conditions, or need clean control with the least added climate load. It is also the sensible option when your team cannot support combustion maintenance every day.

Consider a fuel-fired generator only if your fan-and-pad or sealed house is large enough to justify it, fuel supply is dependable, winter heat has value, and you can install full controls and alarms. Account for humidity removal and the possibility that summer ventilation will erase the cost advantage.

For an NVPH, first improve curtain management, crop spacing, irrigation timing and ventilation. The structure itself must be appropriate for the climate and crop. Compare NVPH and fan-and-pad polyhouses before designing an enrichment plan.

Next steps

Measure your current morning CO2, temperature, RH and fan runtime for at least one representative week. Identify the hours when the house is closed, the crop has useful light and temperatures remain safe. Then calculate gas use for that limited window rather than assuming all-day enrichment.

Specify the CO2 equipment separately from the structural package, but plan sensor wiring, safe mounting points and ventilation interlocks during design. For a new house, you can build a material kit and view this week’s live rates, including the GI structure, polyfilm, nets and fittings needed for the chosen protected-cultivation system. Get a qualified local agronomist and equipment technician to review the final CO2 and safety layout before commissioning.

Frequently asked questions

Can I use CO2 enrichment in a naturally ventilated polyhouse?

Only for limited periods when vents and curtains can remain mostly closed without overheating the crop. In normal hot-weather ventilation, the CO2 escapes too quickly to be economical.

Does a CO2 generator increase humidity in a polyhouse?

Yes. Burning LPG or natural gas produces water vapour as well as CO2, so generator operation can raise RH and condensation risk. This is especially important in dense crops during monsoon and winter.

Which is safer: a CO2 cylinder or generator?

A properly installed cylinder system avoids combustion inside the house, but it still has high-pressure and asphyxiation risks. A generator adds fuel, fire and incomplete-combustion risks, so it needs more alarms and maintenance.

What CO2 level should I maintain for polyhouse vegetables?

Many enrichment programmes operate around 700–1,000 ppm in daylight, but the right target depends on crop, light, temperature and ventilation. Begin conservatively and use a calibrated controller rather than manual release.

Can I run a CO2 generator when the exhaust fans are on?

Usually no. Exhaust fans rapidly remove the generated gas and may make the operation uneconomical. The climate controller should normally stop CO2 supply whenever high ventilation is needed.

Build your kit